ARKMICRO USB-UART CABLE DRIVER

Going of another thread here I suspect that the wires in the cable are as follows: I tried the USB device viewer but neither it or windows seems to think there is a connection. Never used one before. I spent almost 2 whole days trying to read information to get this working and its not working. The driver installation program finishes "correctly" however under Device Manager I can never see the Cypress device when zedboard is poweredup. Mon Jun 13, Hi Carlitos, Unfortunatly I haven't encountered your issue in the past.

Uploader:	Aram
Date Added:	12 January 2013
File Size:	17.99 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	9332
Price:	Free* [*Free Regsitration Required]

I have Win 7 x If you try doing it from the computer end of the cable, how are you going to tell which signal is which and what the values are supposed to be?

Arkmicro Technologies Inc. ARK Serial

ArkMicro Arkkmicro 7 Driver. Check for continuity with a multimeter between the end that you cut off and each of the wires on the cut off piece. Tried an old laptop with XP.

And no, there is no SET color coding - manufacturers choose whatever they want. I know its been said you can find the ground by measuring the ohms with a multimeter set to OHM.

You can google how to use a multimeter. If there is no signal, then you may be on the RX line. If you have 4 lines to test, have to guess at RX and unused line. Going of another thread here I suspect that the wires in the cable are as follows: Hooked up the red cable to match up cabpe the 3V3 pad on the router for power and twisted the blue and white just to test out the prolific drivers from the wiki.

And you can use a USB hub if you want also, as long as its powered. That will tell you which each wire is for, and which is tx, rx, and ground. In my uneducated guess, I believe this usb-uary the colors listed above are correct.

DD-WRT Forum :: View topic - CA Cable Not Recognized

Log in Profile View unanswered posts Log in Username: Then compare the wire colour to the picture linked to in the wiki. Hooked up the power and ground to the router.

The driver usb-uarrt program finishes "correctly" however under Device Manager I can never see the Cypress device when zedboard is poweredup. Never used one before. Mon Jun 13, That leaves your other line as RX. Installed the driver and utility from the Serial Recovery Wiki.

Arkmicro nokia CA-42 usb to TTL serial -clone Free Driver Download

Display posts from previous: All these USB to serial cables have a chip inside them. Wrong unfortunately, the multimeter does NOT provide power. Community Projects View Projects. Can some one help me out here? I only see the same COM1 port that has been there before. I measured all the wires. Please try looking at these posts http: You still have to determine what wire is what.

They are very clsoe together on the Zedboard, jeje. So when you touch the red multimeter to 1 wire, and the black multimeter to one of the USB jack ends, you should see 0 Ohm or hear a Beep That means you have the same wire. The post mentioned does not solve my problem. Touch the red multimeter lead to arkimcro other wires one at a time.